
Installin
and Confi
urin
the Module
840 USE 115 00 Version 1.0
17
2.2 Installing the Module
The Ethernet web embedded server module comes full
read
to be installed.
Installation consists of mountin
the module on the backplane and connectin
the
cable.
2.2.1 Are You Really Ready to Install? Check!
Have
ou reviewed the confi
uration and network
uidelines on pa
e 15? You
must meet those
uidelines before installin
the module.
If you are planning to
change the default configuration, stop the controller before installing the Ethernet
web embedded server module.
Modicon also recommends that
ou test to be sure
our Ethernet cablin
is workin
properl
before connectin
it to the Ethernet module. Some suppliers of testin
e
uipment are listed in Appendix D.
2.2.2 Mounting the Module on the Backplane
Mount the module at an an
le onto the two hooks located near the top of the
backplane. Swin
the module down to make an electrical connection with the
backplane I/O bus connector.
Ti
hten the screw at the bottom of the module to fasten it to the backplane. The
maximum ti
htenin
tor
ue for this screw is 2-4 in-lbs
.23 - .45 Nm
.
Figure 10 Mounting an Ethernet Module on the Backplane
I/O Bus
Connector
Module
Hooks
Kommentare zu diesen Handbüchern